These fittings have one end -AN male and the other end male NPT thread at a 90-degree angle to each other. Made of aluminum with an anodized finish.
NOTE: The NPT end seals on the thread itself so no crush washer or O-ring is required to seal. However, the use of teflon tape/sealant is recommended.
NOTE: Photo is for display purposes and depicts a variety of available fittings. Be assured that your order will correspond to your selections in the drop-downs. All fittings in drop-down not necessarily in photo.
Sold individually.
Several purchase options available.
Choose from drop-downs below:
|