RTM Rear Toe Control Arm Bushing Sleeve Spacers: 2g DSM AWD

There are two rear toe control arms found on a 2g DSM AWD:
MR162573 (RH side)
MR162574 (LH side)

MR162573 has been discontinued by Mitsu and is no longer available.  This presents something of a dilemma.  What to do if you wish to replace both toe control arms on your vehicle?  Well, as it happens, RTM has a solution for you.

As it happens, the toe control arms for 2g FWD and 2g AWD are VERY similar to each other.  The only difference is in the width of the bushing sleeve on the inboard end.  On AWD arms, the sleeve is slightly longer than the sleeve on FWD arms.  This means you can take a toe control arm intended for a FWD and "convert" it for use in an AWD by adding a spacer (of the appropriate length) to one side of the inboard sleeve.  That's it.  Easy peasy. 

May we present the RTM Rear Toe Control Arm Bushing Sleeve Spacers for 2g DSM AWD.  These spacers are made in-house here at RTM from stainless steel so they should outlast your vehicle.  They are sized to precisely match the difference in widths between the OEM FWD rear toe control arms inboard bushing sleeves and the AWD sleeves. These spacers allow you to purchase OEM 2g FWD rear toe control arms (which are still readily available) and use them in a 2g AWD.

NOTE: Photo is for display purposes and depicts a pair of spacers.  Be assured that your order will correspond to your selection in the drop-down.

Application:
DSM (1995-99) AWD with OEM FWD rear toe control arm(s).

Available individually or as a pair.
Choose from drop-down below: