-AN Male to NPT Male (Brass/Steel)

These fittings have one end -AN male and the other end NPT male thread. The angle of each fitting is noted in the drop-down menu. Made of either brass or steel (as noted).

NOTE: The NPT end seals on the thread itself so no crush washer or o-ring is required to seal. However, the use of Teflon tape/sealant is recommended.

NOTE: Photo is for display purposes and depicts a variety of available fittings. Be assured that your order will correspond to your selections in the drop-down. All fittings in drop-down not necessarily shown in photo.

Sold individually.

Available in a number of sizes.
Choose from drop-down below: